10.600
  • 10.600
  • 10.600

Overspeed governors with remote reset of safety switch short base 600

• Overspeed governors with remote reset of safety and switch short base.
• Centrifugal force drive.
• Pulley diameter 200 mm.

More details

 
More info

Overspeed governor with special device for the rearmament by remote control of the safety contact in elevators without access to the governor.
Two electromagnets that act by means of a pulsating signal of 24VDC return the lever of the electrical safety device to its initial position after triggering and interlocking of the governor.

These overspeed governors are set in motion when the levers open by centrifugal force, both in ascents and descents, when the cabin overspeeds. The operation system guarantees that the limiter operation is totally silent as there in no part rubbing on another.

These overspeed governors are valid for setting off instantaneous grip gears with rollers, which are instantaneous with a cushioning and progressive effect.

In descents, overspeeding causes the levers to remain blocked in an interlocking stop designed for that purpose. There is a special device situated on one side of the overspeed governor, which only comes into action in the blocking during ascents. This consists of a rotary lever which is set in motion by the lever of the electric safety device when this is activated by overspeeding during ascent. The special device lever then remains in a position in which one extreme produces a stop at the base of the overspeed governor, and the other interferes with the levers of the overspeed governor as they pass by, thus causing a lock in the ascent.

Associated with the overspeed governor, the assembly counterweight or return pulley should be assembled in such as way as to provide the necessary tension on the cable for the grip gear to work. The return pulley is attached to the lift guide by means of a plate and three flanges, the pulley and the counterweight being suspended from this plate. The electric safety device is also attached to the plate at the bottom, and this will be activated in the event of the overspeed governor cable breaking or loosening.

 
Data sheet
Weight governor with one groove Ø200 mm 7,75 kg
 
Features

 

Polea
Pulley / Poulie
Cable
Rope / Câble
Velocidad Nominal
Nominal speed
Vitesse nominale
Velocidad de Enclavamiento
Tripping speed
Vitesse d’enclenchement
Subida y bajada
Up & Down
Ascente & Descente
Solo bajada
Only Down
Descente
Ø200 mm
Ø6 - 6,5 mm
≤ 1,60 m/s
0,64 ÷ 2,15 m/s
▲ ▼
Otras velocidades consultar - Other speeds consult - Autres vitesses consultez

 

Ref.
Contacto
sobrevelocidad
Overspeed contact
Contact de Survitesse
Enclavamiento
tripping
verrouillage
Polea
pulley
poulie
Polea Tensora / Tension weight / Tension pulley
PA6 + Fibre Glass
Pulley FG-25
Install on top
Pack chasis
Reduced size
Pulley
with springs
10.600
Manual
(1NC + 1NO)
Polea Simple
One Groove
Poulie Simple
10.064.0A
10.064.FA
10.064.0B
10.064.0C
10.064.0D
- - -
12.600
▲ ▼
12.064.0A
12.064.FA
12.064.0B
12.064.0C
12.064.0D
12.064.0M

 

9 other products in the same category:

Send a message

Overspeed governors with remote reset of safety switch short base 600

Overspeed governors with remote reset of safety switch short base 600

We will never spam you